Engine

Displaying 1 to 9 (of 9 products)

Product Image	Item Name-	Price
	GENERATOR/ALTERNATOR/MAGNETO ROTOR PULLER A modified 120mm-long class 10.9 bolt used to remove the generator, magneto or alternator rotor. For all air cooled twins 1951-1995 and R24 R25 R26 &...	$12.00 Add:
	PUSHROD TUBE DRIFT I 1951-95 AIRHEADS DRIFT 1: Replaces Matra 530a, used to remove/install the chromed tubes on the top of the 1951-69 cylinders and I believe also all post 1969 airheads....	$19.00 Add:
	MANY-IN-ONE TOOL all TWINS 1951-1969 Complete engine dis/reassembly tool allows removal of the crankshaft so you can clean the slingers. It holds the flywheel, removes the timing case...	$222.00 Add:
	PUSHROD TUBE DRIFT II 1951-95 AIRHEADS DRIFT 2: Replaces BMW 211 (11.1.600) used to push the chromed ring on the pushrod tube against the rubber grommet in the engine block to prevent oil...	$14.00 Add:
	41mm FLYWHEEL BOLT SOCKET 1/2" drive impact socket with the end faced flat to ensure it doesn't slip off the shallow head of the flywheel bolt while you're torquing it to 168...	$41.00 Add:
	I-TOOL R24 R25 R26 & R27 CYCLES (and for ISETTA 300 & 250 CARS) This tool is for disassembly and reassembly of the single cylinder engines to provide slinger access and/or other bottom-end work. It holds the...	$217.00 Add:
	R24 R25 R26 & R27 UPGRADE FOR THE MANY-IN-ONE If you have a Many-In-One tool you can combine this upgrade with it instead of purchasing a complete I-Tool	$164.00 Add:
	REAR MAIN BEARING PULLER (PART OF THE MANY-IN-ONE TOOL) If you purchased a Many-In-One tool before 16 Feb 1996, and want to pull the rear main bearing without crushing the slinger, that is what this tool...	$36.00 Add:
	REAR MAIN BEARING ALIGNER The R68, R69s, R69 and the R50s use a barrel bearing to support the rear of the crankshaft (very nice). This tool aligns the bearing while it is...	$39.00 Add: