| Product Image |
Item Name- |
Price |
 |
Pulls the steering head bearing outer race from the frame. Works on virtually all BMW's since 1970 with 320/28 bearing. Split ring is made of steel... |
$62.00
Add:
|
 |
For removing the steering head bearing from the triple tree. Bottom piece is machined from a heat treated steel alloy. This is a tough tool made for... |
$62.00
Add:
|
 |
Includes both the outer race and inner race steering head bearing pullers, plus everything you need to reinstall the races in the frame and the... |
$119.00
Add:
|
 |
Plate used to determine if one tube is cocked in front of the other. |
$25.00
Add:
|
 |
Removes and installs the outer race and stock grease seal of the front (1955-69 Earles) and rear (1955-1984) tapered roller bearings used on all dual... |
$43.00
Add:
|
|
Swing arm seal for up to 1980 airheads - ground steel outside diameter so as not to pop out during greasing |
$6.00
Add:
|
|
This tool removes the front fork filler caps on US/2's /5 /6 and /7 and the threaded rings used in the bottom of the /2 and some /5 telescopic forks.... |
$22.00
Add:
|
|
Pin wrench that will remove/install the threaded rings in some /5 (the later ones with the smaller diameter pin holes) and all /6 and /7. |
$22.00
Add:
|
|
If you purchased the fork cap pin wrench you can replace the threaded pins in that tool with these so that you can remove/install the threaded rings... |
$7.00
Add:
|
|
If you purchased the fork tube threaded ring pin wrench you can replace the threaded pins in that tool with these so that you can remove/install the... |
$7.00
Add:
|
